Err Msg: SYS Is Unable to Operate on Target Drive (96496)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.22
• Microsoft Windows 95
This article was previously published under Q96496
This information applies to both Microsoft DoubleSpace and Microsoft
DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for
commands and filenames.
SUMMARY
If you try to run SYS.COM on a drive that has been compressed with
DoubleSpace, you may receive the following error message:
SYS cannot operate on target drive
To transfer the MS-DOS system files to your hard disk drive, you need
to specify the host drive for C. For example, type sys a: h: at the MS-DOS command prompt and then
press ENTER. To determine your host drive for drive C, type dblspace
/list at the MS-DOS command prompt and
then press ENTER.
Modification Type: |
Major |
Last Reviewed: |
12/17/2000 |
Keywords: |
KB96496 |
|