MORE INFORMATION

You can automate the compression of the RAM drive with the following procedure:

• Create RAM drive. For example, to create a 1-megabyte (MB) RAM drive in extended memory, place the following statement in your CONFIG.SYS file:

      device=c:\dos\ramdrive.sys 1280 /e


• Restart your computer to load the RAM drive.

NOTE: MS-DOS assigns the next available drive letter for the RAM drive. For example, if you only have one hard disk drive (C), the RAM drive is assigned the drive letter D. This procedure uses drive D as the RAM drive.
• Compress the RAM drive. For example, to compress drive D, type the following at the MS-DOS command prompt and the press ENTER:

dblspace /compress d:


• Resize the compressed drive to its maximum size (and thereby reduce the size of the host drive to zero bytes). For example, type the following at the MS-DOS command prompt and then press ENTER:

dblspace /size /reserve=0 d:


• Change the CVF attributes so the file can be copied. For example:

      attrib h:\dblspace.000 -s -h -r

This example assumes the host drive is drive H. To determine your host drive, type dblspace /list at the MS-DOS command prompt. Write the drive mapping information down, because you need it in step 5.
• Copy the compressed volume file (CVF) to your hard disk drive.

To avoid having to recompress the RAM drive each time you start your computer, you must store the CVF on your hard disk drive. This requires approximately 1 MB of space.

To copy the compressed volume file to your hard drive, type the following at the MS-DOS command prompt:

copy h:\dblspace.000 c:\dos\ramcvf.000

Since this file cannot be compressed (it already is), you should copy it to an uncompressed drive.
• Add the following lines to your AUTOEXEC.BAT file so that the CVF is copied to your RAM drive and mounted each time you start your computer.

REM Copies and Mounts CVF to RAM drive
copy c:\dos\ramcvf.000 d:\dblspace.000
dblspace /mount=000 d: /newdrive=h:

Substitute the appropriate drive letters for C, D, and H. Drive C should be the uncompressed drive on which you store the RAM drive CVF; drive D is the RAM drive, and drive H is the host drive.
• Restart your computer. To determine if the procedure worked, type dblspace /list at the MS-DOS command prompt and press ENTER.

WARNING: Any information stored on a RAM drive is lost when you restart or turn off your computer. To prevent data loss, copy any file you want to save from your RAM drive to your hard disk drive before turning off your computer.

NOTE: Since DoubleSpace uses a 512-byte sector size, RAM drives must be created with a 512-byte sector size so that DoubleSpace can compress the drive. If a RAM drive is created with a sector size of 128 bytes or 256 bytes, DoubleSpace does not recognize the drive as available for compression. The default value for the sector size of a RAM drive created with RAMDRIVE.SYS included with MS-DOS 6.0 is 512 bytes. For information on changing the sector size of a RAM drive, type the following at the MS-DOS command prompt and press ENTER: