MIRROR Command Returns "Invalid Parameter(s)" Error (69768)



The information in this article applies to:
    Microsoft MS-DOS operating system 5.0

This article was previously published under Q69768

SYMPTOMS

When using the MS-DOS version 5.0 MIRROR command, you may receive the following error message:

Invalid parameter(s) specified.

CAUSE

This error message is returned when you attempt to use the MIRROR command on an ASSIGNed, JOINed, SUBSTed, or network drive. The MIRROR command (including its delete tracking function) is not intended to be used on ASSIGNed, JOINed, SUBSTed, or network drives.

Modification Type: Major Last Reviewed: 11/23/1999
Keywords: KB69768