Err Msg: Setup Is Unable to Identify Your Hard Drive's... (122159)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q122159
SYMPTOMS
The following error is displayed when you run Setup on a system with a SCSI
device that is not a hard disk drive and is set to ID 0 or ID 1:
Setup is unable to identify your hard drive's startup partition.
CAUSE
SCSI ID 0 and ID 1 are reserved for SCSI hard disks. Setup treats devices
mounted as SCSI ID 1 or ID 0 as hard disk devices. The device given ID 0 or
ID 1 does not respond as appropriate, generating the above error message.
RESOLUTION
To work around this problem, reconfigure the device to ID 2 or higher and
then rerun Setup.
| Modification Type: |
Major |
Last Reviewed: |
11/22/1999 |
| Keywords: |
KB122159 |
|