Detailed Description of INTERLNK Parallel Cable Pinouts (121246)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.21
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q121246
SUMMARY
The following signal descriptions are for the parallel cable pins required
to use Interlnk.
Pin 2: Data Bit 0 Active when High
Pin 3: Data Bit 1 Active when High
Pin 4: Data Bit 2 Active when High
Pin 5: Data Bit 3 Active when High
Pin 6: Data Bit 4 Active when High
Pin 10: Acknowledge Active when Low
Pin 11: Busy Active when High
Pin 12: Out Of Paper Active when High
Pin 13: Select Active when High
Pin 15: Error Active when Low
Pin 25: Ground
MORE INFORMATION
Descriptions of parallel and serial cables required to run Interlnk can be
found in MS-DOS Help. For more information, type help interlnk-- notes at the MS-DOS command prompt and then press
ENTER.
Modification Type: |
Major |
Last Reviewed: |
11/19/1999 |
Keywords: |
KB121246 |
|