Err Msg After Running BUSETUP.EXE: Wrong DBLSPACE.BIN Version (114362)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.21
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q114362
SYMPTOMS
This information applies to both Microsoft DoubleSpace and Microsoft
DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands
and filenames.
When you have an MS-DOS 6 DoubleSpace-compressed C drive and you install
MS-DOS 6.21 Upgrade, Setup installs the MS-DOS files on the host drive
for C. As a result, you receive the following error message when you
restart your computer after MS-DOS 6.21 is installed:
wrong dblspace.bin version
When this occurs, your compressed drive is left unmounted.
CAUSE
This problem occurs when you boot your computer from the MS-DOS 6.21
Upgrade Disk 1, exit Setup (BUSETUP.EXE), and then try to run Setup
(SETUP.EXE) from the A prompt.
RESOLUTION
To correct this problem:
• Uninstall MS-DOS 6.21 Upgrade.
• Boot your computer from drive C.
• Run MS-DOS 6.21 Upgrade Setup from Setup Disk 1.
Modification Type: |
Major |
Last Reviewed: |
11/21/1999 |
Keywords: |
KB114362 |
|