Stacker Conversion ErrMsg: Dblspace Was Not Able to Convert... (111758)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
This article was previously published under Q111758
SYMPTOMS
DoubleSpace may not be able to convert a Stacker 3.0 compressed drive if
the stacked volume has a filename other than STACVOL.DSK. If the stacked
volume is not named STACVOL.DSK, you may receive the following error
message:
Dblspace was not able to convert your Stacker drives to dblspace format
CAUSE
The conversion process searches specifically for the stacked volume named
STACKVOL.DSK.
RESOLUTION
To correct this problem, rename the stacked volume STACVOL.DSK. In
addition, change the reference to the stacked volume in the CONFIG.SYS
file. For example:
device=c:\stacker\stacker.com c:\stackvol.dsk
MORE INFORMATION
The Stacker product included here is manufactured by STAC Electronics, a
vendor independent of Microsoft; we make no warranty, implied or otherwise,
regarding this product's performance or reliability.
Modification Type: |
Major |
Last Reviewed: |
10/10/2003 |
Keywords: |
KB111758 |
|