Using SYS.COM After Stacker Version 3.1 Is Installed (107126)


The information in this article applies to:
    • Microsoft MS-DOS operating system 6.0
    • Microsoft MS-DOS operating system 6.2
    • Microsoft MS-DOS operating system 6.22
This article was previously published under Q107126

SUMMARY

This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames.

STAC Electronics Stacker 3.1 modifies the DBLSPACE.BIN file to allow access to Stacker-compressed volumes; however, Stacker does not change the DBLSPACE.BIN filename.

MORE INFORMATION

The command SYS.COM, which is supplied with Microsoft MS-DOS 6.x, normally generates the following four files: 
   IO.SYS
   MSDOS.SYS
   COMMAND.COM
   DBLSPACE.BIN
If Stacker 3.1 is present and you use SYS.COM to make a bootable floppy disk, the Stacker 3.1 version of DBLSPACE.BIN is generated and placed on the disk along with the other system files. If you use this floppy disk, a STAC Electronics copyright message is displayed during startup. If you boot your MS-DOS 6.0 or 6.2 system with this disk and DoubleSpace is installed, the drive cannot mount because DBLSPACE.BIN is now controlled by Stacker 3.1.

NOTE: Microsoft can neither guarantee nor support the functionality of the Stacker DBLSPACE.BIN file.

If Stacker 3.1 is present, the only reliable methods to create an MS-DOS 6.0 or 6.2 startup disk are:
    • Run SETUP /F using the MS-DOS 6.0 or 6.2 Upgrade disks. -or-


    • Copy the DBLSPACE.BIN file found on the MS-DOS 6.0 or 6.2 Uninstall disk to the bootable floppy disk.
Stacker 3.1 is manufactured by STAC Electronics, a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type: Major Last Reviewed: 11/22/1999
Keywords: KB107126
©2002 Microsoft Corporation. All rights reserved.