Err Msg After Uncompressing: You Cannot Access Any... (105260)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q105260
SUMMARY
This information applies to both Microsoft DoubleSpace and Microsoft
DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands
and filenames.
SYMPTOMS
After removing MS-DOS DoubleSpace, you may receive the following error
message:
You cannot access any DoubleSpace drives because the DoubleSpace
driver, DBLSPACE.BIN, is not installed.
CAUSE
This error is generated if DoubleSpace fails to remove any
DEVICE=C:\DOS\DBLSPACE.SYS commands from your CONFIG.SYS file. This
situation typically occurs if you have followed the sequence below.
• Installed MS-DOS 6.0.
• Installed DoubleSpace.
• Installed MS-DOS 6.2.
• Uncompressed your DoubleSpace drives.
• Removed MS-DOS 6.2.
RESOLUTION
To work around this situation, edit your CONFIG.SYS file and remove
all DEVICE=C:\DOS\DBLSPACE.SYS commands.
Modification Type: |
Major |
Last Reviewed: |
11/22/1999 |
Keywords: |
KB105260 |
|