DBLSPACE ERR Msg: Invalid DBLSPACE.INI Setting: SWITCHES=/N (104034)


The information in this article applies to:
    • Microsoft MS-DOS operating system 6.0
    • Microsoft MS-DOS operating system 6.2
This article was previously published under Q104034

SYMPTOMS

If you modify the DBLSPACE.INI file with the DBLSPACE /SWITCHES command in MS-DOS 6.2 and then uninstall 6.2 and use MS-DOS 6.0, you receive one of the following error messages when you boot your computer:

Invalid DBLSPACE.INI setting: SWITCHES=/N
Invalid DBLSPACE.INI setting: SWITCHES=/F
Invalid DBLSPACE.INI setting: SWITCHES=/FN

CAUSE

These switches are not valid for the MS-DOS 6.0 DBLSPACE.INI file.

RESOLUTION

To work around this problem, edit the DBLSPACE.INI file and then add the switches to the CONFIG.SYS file. For example:

    • Use the ATTRIB program to clear the DBLSPACE.INI file attributes. For example: 
          attrib -r -h -s h:\dblspace.ini
    To determine which drive is your host drive, type dblspace /list at the MS-DOS command prompt and then press ENTER.
    • Using MS-DOS Editor, edit the DBLSPACE.INI file and remove the SWITCHES entries.
    • Save the DBLSPACE.INI file.
    • Edit the CONFIG.SYS file on drive C and add the SWITCHES entries.
    • Save the CONFIG.SYS file and exit MS-DOS Editor.
Modification Type: Major Last Reviewed: 10/10/2003
Keywords: KB104034
©2003 Microsoft Corporation. All rights reserved.