System Hangs When SCSI Driver Is Loaded After DBLSPACE.SYS (103668)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q103668
This information applies to both Microsoft DoubleSpace and Microsoft
DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands
and filenames.
SYMPTOMS
SCSI device drivers loaded high or loaded after MS-DOS 6.2 DBLSPACE.SYS in
the CONFIG.SYS file may cause the system to stop responding (hang).
WORKAROUND
To work around this problem, load your SCSI device driver before
DBLSPACE.SYS in the CONFIG.SYS file. If your system still hangs, load
the device driver low (that is, change "DEVICEHIGH=" to "DEVICE=" and
remove the /L parameter). For example, change
devicehigh /L:1,1234 =c:\scsi.sys
to:
device=c:\scsi.sys
| Modification Type: |
Major |
Last Reviewed: |
11/25/1999 |
| Keywords: |
KB103668 |
|