Unable to Access Corel LS2000 SCSI After Upgrading (101566)
The information in this article applies to:
• Microsoft MS-DOS operating system 6.0
• Microsoft MS-DOS operating system 6.2
• Microsoft MS-DOS operating system 6.21
• Microsoft MS-DOS operating system 6.22
This article was previously published under Q101566
SYMPTOMS
You may be unable to access the Corel LS2000 SCSI device after upgrading to
MS-DOS.
CAUSE
Corel Technical Support has confirmed that the device drivers typically
used to access the LS2000 SCSI drive cannot automatically locate the
address range at which the device's adapter ROM resides. This problem does
not occur with previous versions of MS-DOS.
WORKAROUND
To work around this problem, specify the address range used by the
LS2000 when you load the SCSI device drivers in the CONFIG.SYS file.
Modification Type: |
Major |
Last Reviewed: |
11/23/1999 |
Keywords: |
KB101566 |
|